Reason of watch does not work - 2015 Replica WatchesStop and go to watch two scenarios: quartz and mechanical watches. Stop and go watch different reasons will be different
Reasons not go quartz watch
- 1, quartz watch battery without electricity or lack of capacity, a new battery on the line. When quartz watch suddenly do not go, this is the first we have to take into account.
- 2, the contact is not good, mostly dirt on the positive and negative contact spring, and the battery is bad. First, the contact surface sufficiently cleaned, and then re-assembled.
- 3, when the quartz watch, when exposed to a magnetic field, affected by magnetic fields will stop walking. But rest assured, quartz watches with mechanical watches are not the same, it will not be magnetized. Just leave within the magnetic field range on the right.
- 4, the coil circuit, due to oxidation or man-made, so that the coil is damaged, you can check it out by a multimeter, generally need to be replaced.
- 5, wheel system failure, this happens because the dirt between the teeth, or foreign body, the wheel train stuck between teeth with each other. Should be cleaned, remove foreign bodies.
- 6, no output signal of the quartz watch, other aspects were examined, this is generally an integrated circuit board failure caused, in which case you need to replace the entire circuit boards, this is a relatively serious problem.
Solution: We can get the watch service shop to check if the reason is because the battery can replace the battery, if the watch itself is a circuit board or quality problems can be directly asked for a good table. Of course, buy a new table for this situation is extremely rare, usually worn around 2 quartz exemplar appeared without walking more.
Mechanical watch is not the reason to go
Mechanical watches do not go how to do? Mechanical watches is usually divided into the following two categories: manual winding and automatic winding watches. Manual winding watches are relying on hand-powered, if the watch suddenly stop and go, you have to consider the power shortage. Manual winding watch should be winding once a day at the same time, the watch in the next 24 hours there is enough energy operations.
Automatic watch is the principle by automatic Tuo can be rotated in any direction on the role of the self-winding mechanism of a wound running. Usually automatic watches should be worn every day in the hands of eight hours or more to make up for additional capacity, but it is not absolute. So if you do not wear a long time, or after wearing inadequate exercise, can lead to mechanical watches do not go. For such cases, you can use manual winding manner. It is worth noting that more than 40 hours have not worn the self-winding watch, should be worn again, the crown is rotated twenty times to start the movement of the drive system again.